1/29/15

Today, I installed encoders on my squarebot but only used time and motor power to complete this course.

1/28/15

1/27/15

1/22/15

1/21/15

1/20/15

1/15/15

First blink

New rewritten code with if/else statement

 Using button with LED and buzzer

 Powering a motor and adapting it with a thermistor.

1/13/15

Made circuit using a transistor and a few resistors.

Used finger to complete the circuit.

Measured the current in the circuit using two voltmeters.

1/08/15

Oscillating light sing relay and capacitor

Light switch using relay.

1/07/15

Used multimeter to measure voltage coming from wall plug.

Then, used multimeter to measure voltage from different batteries.

We then used the multimeter to measure the resistance of a few resistors and compared it to the known values.

Made circuits using LEDs and different resistors

Built a square bot

1/06/15

Circuit board with resistors soldered on

Our first task was to solder on some resistors on the board.

Soldered wires

Next, I cut off the end of an AC/DC adapter and solder on some other wires to the positive and negative ends of the adapter. I then used shrink wrap to prevent the wires from touching.

Bread board with LED and 100 ohm  resistor

Using the AC/DC adapter from before, I used it to power an LED on a bread board. However, a resistor must also be used in order to prevent the LED from blowing out.

Bread board with LED and 470 ohm resistor   

I then used a 470 ohm resistor in the circuit and observed that it light up less dimly.